Quantitative trait loci for tibial bone strength in C57BL/6J and C3H/HeJ inbred strains of mice.

Document Type

Article

Publication Date

2010

Keywords

Bone-Density, Chromosomes-Mammalian, Crosses-Genetic, Elastic-Modulus, Genotype, Mice-Inbred-C3H, Mice-Inbred-C57BL, Quantitative-Trait-Loci, Tibia, Weight-Bearing

First Page

21

Last Page

27

JAX Source

J Genet 2010 Apr; 89(1):21-7.

Abstract

Three-point bending technology has been widely used in the measurement of bone strength. Quantitative trait loci (QTLs) for bone strength have been identified using mouse femurs. In this study, we investigate the use of mouse tibiae in identification of QTLs that regulate bone strength. Mouse tibiae were from a F(2) population derived from C57BL/6J (B6) and C3H/HeJ (C3H). Three-point bending was measured using ISO 4049, with the support width adjustable to accommodate specimen sizes outside the scope of ISO 4049. The strain rate is selectable from 0.05 to 500 mm per min. All stress strain diagrams are recorded and retrieved in digital electronic form. Genome scan was performed in The Jackson Laboratory (TJL). QTL mapping was conducted using Map Manager QTX software. Data show that (i) both elastic modulus (stiffness) and maximum loading (strength) value appear as normal distributions, suggesting that multiple genetic factors control the bone strength; (ii) 11 QTLs, accounting for 90% of variation for strength, have been detected. More than half QTLs of three-point bending are located on the same locations of bone density earlier identified from mouse femurs; (iii) a major QTL of femoral and vertebral bone mineral density (BMD) was not detected for bone strength of tibiae; (iv) the QTL on chromosome 4 has extremely high LOD score of 31.8 and represents 60% of the variation of bone strength; and (v) four QTLs of stiffness (chromosomes 2, 11, 15 and 19) have been identified.

Link to Full Text

Share

COinS